Effect of delayed light curing of a resin composite on marginal integrity in cylindrical dentine cavities.

The effect of delayed light curing of resin composite on marginal adaptation has been examined by measuring the wall-to-wall polymerization contraction gap when using a commercial resin composite together with experimental dentine bonding systems to restore cylindrical preparations in dentine. Morphological changes in dentine during dentine bonding procedures were observed using a scanning electron microscope. In a previous report, the contraction gap width for a resin composite increased when irradiation of the resin system was delayed, despite the use of a dentine bonding system considered to be 'contraction' gap free. Such deterioration in marginal adaptation was minimized by use of an experimental dentine primer, 40% erythritol methacrylate aqueous solution (EM), followed by the use of a commercial dual- or autocured dentine bonding agent. Under scanning electron microscopy, the dentine surface microstructure became unclear after EM priming, and a polymer film was detected after polymerization of the dual-cured dentine bonding agent. The hydrogelled primer and the formation of a polymer network on the dentine surface may prevent the flow of fluid from the pulp through the dentine tubules, and maintain marginal integrity if there is delay in light curing of light-activated resin composite systems.